Crystal Oscillators
Instructions for defining crystal oscillator constraints, covering detection criteria, configuration fields, and current limitations.
This constraint is designed to position oscillators near their drivers, minimizing phase noise and startup problems.
Automatic Detection
Crystal oscillators are automatically detected if they meet the following criteria:
A crystal oscillator component with a reference designator begins with an
XorYBoth pins of the crystal oscillator are directly connected to the same parent component or driver.
Load-limiting Resistors This constraint currently does not detect or function on crystals with load-limiting resistors
Constraint Details
Set up crystal oscillator constraints in the "Crystal Oscillators" section of Circuit Comprehension.
To add a crystal oscillator constraint, enter the following information:
Crystal (reference designator)
Parent component
Parent pin 1
Parent pin 2
If Quilter did not automatically detect your Crystal Oscillator, you can add it manually by pressing the Add button.
Physics Rule Checks
The PRCs that validate this constraint after compile are:
Pin Distance calculates the Euclidian distance between the closest edges of two pins.
Layer Switch Count finds the number of times there is a layer switch in a trace path between two pins
Trace Path Length calculates the trace length between two pins of interest.
Ground Plane Overlap determines if the ground plane below net traces overlaps at all relevant points.